Kinetik Pain reliever DT1 - Manual (Page 10)

9
Using your Dual Channel TENS Digital Pain Reliever
Please ensure the gel pads are correctly attached and placed on the desired area before switching the unit on.
1: Press the “ON/OFF” button to switch the unit on.
2: Press the “A” button to select channel A. “CHANNEL A” will be displayed on the left hand side of the
LCD. When “CHANNEL A” is displayed, the mode and intensity settings on this channel can be chosen.
3: Press the “B” button to select channel B. “CHANNEL B” will be displayed on the right hand side of the
LCD. When “CHANNEL B” is displayed, the mode and intensity settings on this channel can be chosen.
Please note, channel A and B have to be set independently. They cannot be set up at the same time. If you want
to use both channels together, set channel A mode and intensity, this will start immediately. Then set channel B
mode and intensity (channel A cycle will finish before channel B).
4: To choose a mode setting, press the “mode” button. The LCD will display on either the left hand side
or right hand side of the LCD, depending on whether channel A or channel B has been chosen. The “ ”
or “ ” buttons can be used to choose the desired mode setting.
5: To choose an intensity setting, press the “int” button. The LCD will display on either the left hand side
or right hand side of the LCD, depending on whether Channel A or channel B has been chosen. The “ ”
or “ ” buttons can be used to choose the desired intensity setting.
6: Press the “ ” button to move up by one level when choosing your mode or intensity settings on the
selected channel. (There are 8 modes and 8 levels of intensities to choose from- 1 being the lowest
intensity, 8 being the highest intensity).
7 : Press the “ ” button to move down by one level when choosing your mode or intensity settings on
the selected channel.