Kinetik Pain reliever DT1 - Manual (Page 8)

7
Using your Dual Channel TENS Digital Pain Reliever
How to connect the gel pads to the output cable:
Preparation before using the unit
1. This unit requires 4 x AAA batteries (included).
2. To insert/replace batteries, remove the battery compartment cover at the back of the unit and
insert the batteries, observing correct polarity. Replace the battery compartment cover securely.
3. Attach the gel pads to the output cables and insert into the respective sockets, channel A and
channel B.
4. Attach the gel pads to the area of pain. Please revert to the Gel Pad Positioning section on page 12.
Each gel pad is pre-fixed with a cord-socket and protected by a transparent film. Connect the output cable via
the cord-socket. Remove the layer of film and place that side of gel pad to the skin. Press to ensure adhesion.
IMPORTANT NOTE: When removing the gel pads from the skin, peel off from one corner of the gel pad.
DO NOT pull the cord-socket or cable to remove.
Please note:
If the gel pads do not attach to skin or pads please refer to the troubleshooting section on page 15
• If gel pads are dirty, wipe with damp, lint free cloth or replace with new ones.
• Do not clean the pads or adhesive gel pad with any chemicals.
• Replacement Pads are available from your retailer.