Kinetik Pain reliever DT1 - Manual (Page 12)

11
Programme Selection
• The output intensity will be displayed on the LCD as a number from 1 – 8. (1 is the lowest and 8 is the
highest).
• The unit has a memory function - if a particular mode setting is chosen then it will remain on that mode
even when the unit is switched off and switched back on. (Note: the time and intensity will be set to the
default 15 and 0 respectively).
• When the intensity mode is chosen (1-8) the time setting function starts to work. It can be seen as the
flashing dot on the LCD display and flashes once per second.
• When the device is on and the mode setting or intensity is changed, it will not affect the timer which will
continue to count down the remaining time. When the mode setting is changed the intensity will default
to 0. The device will turn off automatically when the set time has elapsed (15 minutes).
• When the treatment cycle has finished remove the gel pads carefully from the skin.
Important note: When removing the gel pads from the skin, peel off from one corner of the pad. DO NOT
pull the cord socket or cable to remove as this may lead to injuries or malfunctioning.
What can I treat?
The Dual Channel TENS Digital Pain Reliever can treat many different types of pain. Following are diagrams of
where to place the gel pads for the most common forms of pain. For other areas of pain, place the electrodes
on either side of the area. Never place the electrodes on the head, face, throat, back of the neck, chest area,
eyes, oral cavity, sexual organs or onto the spine or bones.
Caution:
• Affix the gel pads so that they do not overlap one another and are approximately 4-6 inches apart.
• Be sure not to move the gel pads to another part of your body without turning off the power first.