KV2 Audio SAC2 - Manual (Page 10)

POWER
WWW.KV2AUDIO.COM
KV2 AUDIO, MANUFACTURED IN THE EUROPEAN UNION
230 VAC, 50/60 Hz
MAX 30WATTS
R L
PHASE PHASE PHASE PHASE SUB EQ
ON
OFF
SUB MODE
MONO
L / R
LIM - T
FAST
SLOW
HI
OUTPUT L R
LOW
OUTPUT L / MONO R / MONO
INPUT
180˚
0˚
180˚
0˚
180˚
0˚
180˚
0˚ SERIAL NUMBER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE
THIS PANEL OR ANY ATTACHED COMPONENTS. NO OPERATOR SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL ONLY. TO
REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
Stereo Master EQ
One of the advantages of the SAC2 is the ability to use the Notch Filters and four-band EQ as both a
Master and Monitor/Fill EQ.
The Low Output can be used to send a full-range PA signal by switching it to DIRECT mode.
The Hi Output can be used to send a full-range signal by switching it to DIRECT mode or as a
High Pass Filter with selectable 70Hz or 120Hz frequency to send signal to Monitor/Fill loudspeakers.
The built in VHD Line Drivers ensure the highest possible signal integrity over long distances.
L - Full Range PA R - Full Range PA
L-Full range
Out
R-Full range
Out
L - Fill in R - Fill in
Using the System
L-Full Range
In
R-Full Range
In
SAC2 Rear view
X OVER
70Hz ON
120Hz
LPF
+10 dB -15 dB
0
+10 dB -15 dB
0
HI OUTPUT LOW OUTPUT
HPF
DIRECT DIRECT
SAC2 Front view
SUB MODE
MONO
L / R
HPF
DIRECT
LPF
DIRECT
R-Hi
Out
L-Hi
Out
Page | 10