KV2 Audio SAC2 - Manual (Page 8)

LOW-R LOW-L HI - L HI - R
0dB
+3dB
-3dB
-8dB
-13dB
+10 dB -15 dB
0
GAIN LIMITER
+15 dB -15 dB
0
LOW
+12 dB -12 dB
0
+12 dB -12 dB
0
+15 dB -15 dB
0
LOW - MID HI - MID HI
-6 dB -12 dB 0 -6 dB -12 dB 0 -6 dB -12 dB 0 -6 dB -12 dB 0
LOW-R LOW-L HI - L HI - R
0dB
+3dB
-3dB
-8dB
-13dB
X OVER
70Hz ON
120Hz
LPF
+10 dB -15 dB
0
+10 dB -15 dB
0
HI OUTPUT LOW OUTPUT
HPF
DIRECT NOTCH LEFT NOTCH RIGHT
HI PASS
40Hz
+10 dB -15 dB
0
ACTIVE
20Hz
EQ
ON
OFF
45 52
80
140
300
500
800
1.3k 1.6k Hz
300 200 450
45 52
80
140
300
500
800
1.3k 1.6k Hz
300 200 450
45 52
80
140
300
500
800
1.3k 1.6k Hz
300 200 450
45 52
80
140
300
500
800
1.3k 1.6k Hz
300 200 450
Output level bar graph indicators
The levels of each individual output are indicated with LED bar
graphs.
DIRECT
X OVER
70Hz ON
120Hz
LPF
+10 dB -15 dB
0
+10 dB -15 dB
0
HI OUTPUT LOW OUTPUT
HPF
DIRECT
Power On LED
Indicates whether the SAC2 is powered on.
Crossover frequency
The “X OVER“ switch allows users to select a crossover
frequency of either 70Hz or 120Hz. The correct frequen-
cy selection depends on the individual characteristics of
the speakers used.
LPF / Direct switch
The crossover's Low Pass Filter can be bypassed by switching to the DIRECT position allowing a full
range signal to pass through the low outputs.
Low Output
Adjusts the LOW OUTPUT levels from -15dB to +10dB.
High Output
Adjusts the HIGH OUTPUT levels from -15dB to +10dB.
HPF / Direct switch
The crossover's High Pass Filter can be bypassed by switching to the DIRECT position allowing a full
range signal to pass through the high outputs.
Features
Front Panel
DIRECT
Page | 8