KV2 Audio SAC2 - Manual (Page 12)

POWER
WWW.KV2AUDIO.COM
KV2 AUDIO, MANUFACTURED IN THE EUROPEAN UNION
230 VAC, 50/60 Hz
MAX 30WATTS
R L
PHASE PHASE PHASE PHASE SUB EQ
ON
OFF
SUB MODE
MONO
L / R
LIM - T
FAST
SLOW
HI
OUTPUT L R
LOW
OUTPUT L / MONO R / MONO
INPUT
180˚
0˚
180˚
0˚
180˚
0˚
180˚
0˚ SERIAL NUMBER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE
THIS PANEL OR ANY ATTACHED COMPONENTS. NO OPERATOR SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL ONLY. TO
REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
2-Way stereo crossover with mono subwoofer
The SAC2 can also be used as a stereo crossover with a mono subwoofer.
The Low Output is used as a mono low pass signal for a subwoofer. The Low Output should be
switched to LPF and the Sub Mode switched to MONO. Either Low Output can be sent to the Sub-
woofer as the Low Outputs now play the same signal.
The Hi Output is used as a stereo high pass signal for mid/hi loudspeakers. The Hi Output should be
switched to HPF and the Left and Right outputs sent to the mid/hi loudspeakers.
The built in VHD Line Drivers ensure the highest possible signal integrity over long distances.
L - Hi/Mid module
Bass module
R - Hi/Mid module
Low, Summed Out
R-Hi Out
L-Full Range
In
R-Full Range
In
L-Hi Out
Low
Summed Out R-Hi
Out
L-Hi
Out
Bass module
Using the System
SUB MODE
MONO
L / R
SAC2 Rear view
Power
amplifier
Page | 12