Landoll SCPH-33 Subsoil Chisel Plow - Manual (Page 9)

1001 7K299
Page 7
MAINTENANCE
After the first 5 or 6 hours of operation, go over the machine and tighten all nuts with lockwashers
which might be loose.
Check shank bolts daily. -Refer to set up instructions for correct tightness.
Normal periodic checks should be made thereafter.
SUPPORT STANDS
Assemble the support stand through the vertical tube at the rear of the frame. Insert the 1/4 x 2 1/4" long cotter
pins in the top holes of the support stand to prevent it from falling out when the machine is raised.
When the machine is idle and not mounted to the tractor, the 1/2 x 3" long clevis pin, inserted in the
middle holes, will prevent the unit from tipping. Then when you raise the machine for working or for
transport, remove the clevis pins, raise the support stand all the way up and insert pin in the lowest
hole. This will keep the support stand up and out of the way while the machine is in use.