Landoll 875 Series Tilloll - Manual (Page 51)

OPERATION AND MAINTENANCE
4-3
Figure 4-2: Transport Locks
Attaching to the Tractor
1. Align the tractor drawbar with the machine. Raise or
lower the Tilloll ring hitch, as needed, using the
swivel jack. Attach the unit with proper size hitch pin.
2. Clean all hydraulic couplings and attach to the
tractor. When properly attached, the hydraulic control
lever should cause the Tilloll to:
a. Lower to the ground when the control arm is
moved forward or downward, and
b. Raise when the control arm is moved backward
or upward.
3. Fully extend the hydraulic gauge wheel cylinders,
and place the cylinder lockouts in the transport lock
position over the cylinder rods. Secure the lockouts
with the lockout pins (See Figure 4-2.)
4. Always place the swivel jack on the interior mount
before setting the machine in motion.
FRAME
GAUGE WHEEL
ARM WELMENT
3/16 HAIR PIN
LOCKOUT PIN
HYDRAULIC CYLINDER
LOCKOUT WELDMENT
trans_lock