Landoll 855 Series Finisholl - Manual (Page 44)

3-10 F-133-0512 Edition
ASSEMBLY INSTRUCTIONS
Hydraulic Installation
NOTE
See Figures 3-8 thru 3-16 and Table 3-1 thru Table 3-3
for hydraulic installation drawings.
1.
Set the depth adjustment to a medium depth (insure
that all are set to the same depth).
2. Install the master cylinders with the base end on the
slide bars of the frame and the rod end on the arms
of the rockshaft (See Figure 3-8.)
3. Install the slave cylinders with the base end on the
slide bars of the wings and the rod end on the arms
of the rockshaft (19’ and larger units only) (See
Figure 3-8.)
4. On 11' and 14' units, install 90
o
elbows and hoses as
shown in Figure 3-11.
5. On 17’ through 27’ units:
a. Install the fold cylinder bracket with four 3/4-10 X
3 screws and lock nuts (See Figure 3-9.)
b. Install base end of 4 X 24 (17' through 22'
models) or 5 X 24 (25' and 27' models) fold
cylinders to fold bracket on frame with ports up.
Pin rod end of cylinder to bracket on wings using
extended pin, washers and cotter pins (See
Figure 3-9.)
c. Install manifold to bracket on frame using 1/2-13
X 3-1/2 screws and nuts (See Figure 3-9.)
d. Install a restrictor O-ring elbow in each port of
the fold cylinders (See Figures 3-12 and 3-13.)
e. Install an O-ring elbow in each port of the lift
cylinders (See Figures 3-12 and 3-13.)
f. Install fittings in the manifold (See Figures 3-12
and 3-13.)
g. Install hoses per Figures 3-12 and 3-13 for the
size of unit assembled. Refer to Table 3-1 for 19'
- 27' model hose lengths.
Figure 3-8: Master and Slave Cylinder Installation
2m410-011261
CYLINDER
COTTER PIN
PIN
DEPTH ADJUSTMENT
SCREW
SLIDE BAR
ROCKSHAFT