Landoll 2430 Weatherproofer I - Manual (Page 35)

ASSEMBLY INSTRUCTIONS
3-15
Disc Gang Installation - Wings
NOTE
See Figure 2-5 for disc gang placement.

DANGER
1. Assemble the disc gang assemblies to the center
frame using 3/4-10 x 11 grade 8 hex head cap
screws, 3/4-10 x 2 hex head cap screws, 3/4-10 x
2-1/4 hex head cap screws, flat washers, and hex
lock nuts (See Figure 3-7.)
NOTE
3/4-10 x 2-1/4 hex head cap screw is used on left rear
wing disc gang as shown in Detail A of Figure 3-3.
Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow disc to roll over or fall onto
any body part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.