Landoll 2410 Weatherproofer I - Manual (Page 34)

3-16 F-620-0912 Edition
ASSEMBLY INSTRUCTIONS
Figure 3-9: Hitch Hose Clamps and Color Designation
Hydraulic Installation
NOTES
Refer to Figure 3-7 for hydraulic diagram for the
2410-6-24 model.
Refer to Figure 3-8 for hydraulic diagrams for the
2410-7-24 and 2410-9-24 models.
1. Install the manifold to the manifold bracket on the
frame using 1/2-13 x 3-1/2 hex head cap screws and
hex lock nuts.
2. Install fittings into manifold according to Figures 3-7
and 3-8.
3. Install wheel lift hoses per Figures3-7 and 3-8.
4. Hold each system of hoses in place using 3/8-16 x 4
hex head cap screw, hose clamps, and hex lock nut
(See Figure 3-9.)
5. Install steel plugs in any remaining open manifold or
valve ports.
6. Install hose wraps around system hoses per hose
identification decal near hose couplers, putting both
hoses inside wrap (See Figure 3-9.) Note that no
yellow hose wrap is used on rigid models.
3/8-16 X 3 OR
3/8-16 X 4 HEX
HEAD CAP SCREW
HOSE CLAMPS
3/8-16 HEX LOCK NUT
2410 hitch hose clamps