Safety decals, Pinching or crushing danger, Moving parts – Landoll ICON 1632RS Grader User Manual
Page 17: Danger, Caution, Danger, high pressure, Horsepower limits, Lubrication, Proper notification, Storage recommendations
SAFETY INFORMATION
3-7
Safety Decals
See Figures 3-3 through 3-5 for decal locations.
NOTE
Replace all missing or damaged safety signs/decals.
Pinching or Crushing Danger
1.
Moving parts that are operated by hydraulic pressure
can cause serious injury or death.
2.
Use extreme caution when working around any
moving part.
3.
Do not allow any person to be on or near the
machine while it is in motion.
Moving Parts
1.
Be aware of all moving parts of the machine.
2.
Do not allow anyone to be near, or on the machine
while operating any moving part.
Danger
1.
Read and understand the operator’s manual before
using the machine.
2.
Allow no person to operate the machine before
reading the manual and being instructed on proper
operation.
Caution
1.
This machine is designed for off road use only.
Danger, High Pressure
1.
High pressure fluid can cause serious damage to
hands and eyes.
2.
Carefully relieve pressure before attempting any
3.
adjustments.
4.
Tighten all fittings before applying pressure.
NOTE
If fluid is sprayed into eyes or injected into skin,
see a
doctor immediately!
Horsepower Limits
1.
Each machine is rated for it’s horsepower limits.
2.
If the posted limits are exceeded, damage to the
machine may occur, and the Warranty will void.
NOTE
300 maximum engine h.p. is only applicable if the grader
is equipped with the 2nd cylinder.
Lubrication
1.
Lubrication information is placed near each zerk.
2.
Proper maintenance should be followed to assure the
working life of the machine.
Proper Notification
1.
Contact the proper authorities before you dig.
2.
When digging in a populated area, it is
recommended that a call be made to area utilities to
establish the local of any buried pipes, lines, or
structures. When digging in open areas, research
and know the local of any underground structures
and objects.
3.
Striking the blades or bits against buried objects can
cause damage to the machine, and is considered as
abuse to the scraper.
Storage Recommendations
NOTE
If the machine is being stored or not in use for a long
period of time, it is recommended that a coating of heavy
grease be applied to the exposed chrome cylinder rods.
This will help to protect the coating from moisture and
rust during this time.
CAUTION
Be certain to remove the cylinder stops before
using the grader. The stops are to be pinned in
the holder, located on the rear frame.
Failure to remove the stops will result in damage
to the stop or cylinder.