Switching the latch connectors – Britax LATCHANCHOR User Manual
Page 18
Switching the LATCH Connectors
17
B
C
A
The LATCH harness must be
switched for proper alignment
in rear facing or forward facing
installations. The seat is sup-
plied with the LATCH harness
fitted in the rear facing posi-
tion. To switch the harness to
the forward facing position,
follow the instructions below:
1
Feed the complete latch har-
ness out through the seat on
the side with the short connec-
tor strap (fig A).
2
Then feed the LATCH con-
nector with the “For use on
Driver's side Latch Anchor”
label first, through the seat
shell as shown (fig B).
Connector labelled, “For use
on Driver's side Latch Anchor”
must be on appropriate side of
child restraint. Verify that har-
ness is not twisted.
3
To move from forward facing
to rear facing, reverse the
above procedure.
FAGalaxy_page proof 2/9/02 4:03 PM Page 17