Lenze E94P v2.0 - Manual (Page 3)

3 P940HBK01B
1 Safety Information
WARNING!
When operating the PositionServo drive remotely with an output module, the motor may
start unexpectedly, which could result in damage to equipment and/or injury to personnel
Make sure the equipment is free to operate in this manner, and that all guards and covers
are in place to protect personnel
The pictographs in Table 1 are used in AC Technolgy documentation to provide safety information
Table 1: Pictographs
Pictograph Signal Word Meaning Consequence if Ignored
DANGER! Warning of Hazardous Electrical
Voltage Reference to an imminent
danger that may result in death
or serious personal injury if the
corresponding measures are
not taken
WARNING! Impending or possible danger
to personnel Death or injury
STOP! Possible damage to equipment Damage to drive system or its
surroundings
NOTE Useful tip: If note is observed,
it will make using the drive
easier
1.1 Persons Responsible for Safety
Operator
An operator is any natural or legal person who uses the drive system or on behalf of whom the drive system
is used
The operator or his safety personnel is obliged to ensure
the compliance with all relevant regulations, instructions, and legislation
that only skilled personnel works on and with the drive system
that the personnel have the Operating Instructions available for all corresponding works
that all unqualified personnel are prohibited from working on and with the drive system
Qualified personnel
Qualified personnel are persons who - because of their education, experience, instructions and knowledge
about corresponding standards and regulations, rules for the prevention of accidents, and operating
conditions - are authorized by the person responsible for the safety of the plant to perform the required
actions and who are able to recognize potential hazards (Definition for qualified personnel to VDE 105 or
IEC 364)
•
•
•
•
•
•