Lenze DDS Function library 8200 Drive - Manual (Page 9)

Function library Lenze8200Drive.lib
Introduction
2−1
l
Lenze8200Drive.lib EN 1.0
2 Introduction
2.1 General
Integrate function library Lenze8200Drive.lib in your PLC program to make frequency inverter
control easier.
Two function blocks are required for this:
1. A function block for the parameterisation of the frequency inverter.
2. Another function block for process data exchange between PLC and frequency inverter.
The parameters can be set via the PLC program. It is possible to select up to 45 parameters.
Parameterisation concepts
The following parameterisation concepts are supported:
·
Parameterisation through direct instructions in the FBs
·
Parameterisation by means of codes ("online" parameterisation possible)
Note!
The frequency inverter must meet the following conditions for frequency inverter control from the
PLC:
·
The factory settings have been loaded.
(For the 8200vector frequency inverter, e. g. under code C0002)
·
The system bus node address is correct.
(For the 8200vector frequency inverter, e. g. under code C0350)
·
The new communication settings of the system bus interface have been accepted by a
Reset−Node.
(For the 8200vector frequency inverter, e. g. under code C0358)
Tip!
Detailed information about the system bus (CAN) and function library LenzeCanDrv.lib can be found
in the Manual "System bus (CAN) for Lenze PLC devices".