Lenze p500 Controller User Manual
Page 5
MA_p500 DE/EN/FR/ES/IT 2.0
5
UL_Warn_p500-M-Install_WiHis_p500
Before starting work, read the operating instructions for the p500 panel
controller. These instructions provide additional important information such
as:
ƒ
the scope of supply
ƒ
application as directed
ƒ
identification of the devices
ƒ
technical data
ƒ
electrical installation
ƒ
operation
ƒ
maintenance
Documentation and tools for Lenze products can be found in the download
section of our website at
http://www.Lenze.com
ƒ To prevent damage to electronic components, only mount/remove the device with
the voltage supply switched off.
ƒ The mounting location always must correspond to the operating conditions specified
in the technical data. If required, take additional measures.
ƒ Continuous and adequate air circulation is essential in the installation space so that
the device’s heat is correctly dissipated. Make sure that the ventilation slots are never
covered.
ƒ When choosing the installation location, ensure that the screen is in an
ergonomically suitable position and that light is unable to cause irritating reflections
on the screen.
ƒ During installation, there is a danger that the controller will fall out of the mounting
cutout. You should therefore secure it to prevent this happening until all screw
clamps have been fitted.
ƒ During mounting, the gasket of the front frame is exposed and can be damaged.
– Handle the gasket with care during mounting.
– Protect the gasket against ultraviolet rays.
– Check the gasket to make sure it is undamaged before you install the device.
ƒ The device must be securely seated in the mounting cutout and the front panel seal
must be correctly fitted. Otherwise, class of protection IP65 will not be achieved on
the front side of the device!
ƒ The heat sink on the rear of the L-force controller becomes very hot during operation.
There is therefore a risk of burns!
– Before working on the device, check the temperature of its heat sink.