Lenze EDK8201BB - Manual (Page 8)

Parameters
MA8201BB 2.0
l
- 4 -
Change parameters and save
Ÿ The parameters can be changed when the controller is enabled.
- The parameter sets (C002) can only be overwritten if the controller is inhibited.
Ÿ Changes of the operating parameters are accepted ONLINE.
Ÿ Changes affecting the controller initialization must be confirmed with SH + PRG.
Acceptance and saving
without cofirmation
(ONLINE)
confirmed with SH +
PRG
confirmed with SH + PRG when
controller is inhibited
A Operating level → [STP] → controller
inhibited
1. Operating level → [PRG] → Code level
2. [ ▲] or [▼] → Code selection
3. [SH] → Parameter set PAR1 (→ [SH] → Parameter set PAR2)
4. When PAR1 ( PAR2) is flashing: [▲] or [▼] → Change parameters 4.
Frequency immediately
operates with the changed
parameter.
5. [SH] → Code level [SH] + [PRG] → Display “STO” ( approx. 1 s) → Code level 5. [SH] Code level
Frequency inverter now
uses the new
parameter.
6. [PRG] → Operating level (changed parameter is saved non-volatile)
B [RUN] → Controller enabled
Frequency inverter now uses the
changed parameter.
Parameter sets transmitted
You can transmit complete parameter sets to frequency inverters of the same series
(820X
® 820X, 821X ® 821X, 822X/824X®822X/824X) using the operating module.
Transmit parameter sets
to the operating module to the frequency inverter
1. Operating level → [STP] → Controller inhibited
2. Operating level → [PRG] → Code level
3. [ ▲] or [▼] → Select C002
4. [SH] → PAR1 is flashing → [▲] or
[ ▼] → C002 = -6-
[SH] → PAR1 flashing → [▲] or [▼] →
C002 = -3- → Transmit PAR1 and PAR2
C002 = -4- → Transmit PAR1
C002 = -5- → Transmit PAR2
[SH] + [PRG] → Display “STO” until transmission is completed → Code level
The parameters of C016, C036, C088, C091, C079 are not transmitted.
5. [PRG] → Operating level (parameter sets saved non-volatile)
6. [RUN] → Controller enabled
Show/Hide Bookmarks