Lenze E82ZMBR1 - Manual (Page 7)

Installation
qaMM
bahUOwj_oN 3.2
l
- 2 -
1. Prepare motor (only for
motor mounting)
A Dismount motor terminal
box
B Dismount motor terminal
board
C The motor connections
must be approx. 15 cm
long, if necessary, extend
the cables
8200mot139
2.
y
Motor mounting
- Screw the housing shell
to the motor with 2
screws M5 x 16 
y Wall mounting:
- Screw the mounting
plate (part of the delivery
package of the motec) to
the wall
- Mount the housing shell
to the mounting plate
using the 2 self-tapping
screws 5 x 18
3. Assign the terminals of the
brake rectifier according to
the connection type ( 3)
82ZMBR1005
4.
y
Motor mounting
- Mount the motec carrier
housing to the housing
shell using 2 M5 x 55
screws  and 2 M5 x 20
screws .
y Wall mounting:
- Mount the motec carrier
housing to the housing
shell using 2 5 x 55
self-tapping screws 
and 2 M5 x 20 
screws.
5. Connect the brake rectifier
to the motec terminals
according to the
connection type selected
( 3)
6. Mains and motor
connection (see Mounting
Instructions for the 8200
motec)
7. Configure the relay output
for brake control!  5
0
1