Back exercises, Reverse grip pulldowns, Muscles worked – Bowflex Motivator Strength Training System User Manual

Page 27: Starting position, Action, Key points, Lying shoulder fly, Finish start finish start 25

Advertising
background image

REVERSE GRIP PULLDOWNS

with the Lat Tower - Shoulder Extension (with elbow

flexion)

Muscles worked:

This exercise emphasizes the latissimus dorsi, teres major and rear deltoid

which make up the large pulling muscles of your upper back. It also involves the muscles on the front of

your upper arms (the biceps group) which are responsible for bending your elbows.

Starting position:

•Facing the power rods, grasp the bar with an underhand grip, at a width determined above.

Then sit on the bench.

•Position your thighs directly under the pulleys and sit upright with your arms extending upward. NOTE:

You may position your hips directly under the pulleys but then you must lean back slightly from hips

(not the waist).

•Maintain good spinal alignment, chest lifted, abs tight and maintain a very slight arch in your lower

back.

Action:

•Initiate the movement by pulling your shoulder blades down and together while

simultaneously drawing your elbows downward to the sides, and then inward, towards your

body.

•At the end of the motion, your arms should be drawn near your sides (although may not be touching

your sides), your shoulder blades should be fully depressed towards your hips and your forearms

must be upward in line with the direction of the cables (not forward).

•Slowly return to the starting position allowing your arms and shoulder blades to move fully upward,

without relaxing the muscles.

Key points:

•Do not lose spinal alignment.

•Keep the lats tightened throughout the entire motion.

LYING SHOULDER FLY

- Shoulder Adduction

Muscles worked:

This exercise emphasizes the latissimus dorsi, teres major and rear deltoid

which make up the large pulling muscles of your upper back, as well as involving your biceps which are

located on the front of your upper arms.

Starting position:

•Lie on your back, head toward the power rods.

•Grasp the handles and straighten the arms out to the sides with your palms facing away from the pul-

leys, knees bent, and feet flat on the floor.

•Tighten your abdominals to stabilize your spine while maintaining a very slight arch in the lower back.

Action:

•Initiate the movement by pulling your shoulder blades down towards your bottom and then

immediately start pulling your arms inward towards the sides of your body with a slow

controlled motion.

•Slowly return to the starting position, allowing your arms and shoulder blades to move back up/out

toward the power rods without relaxing.

Key points:

•Do not lose spinal alignment.

•Keep the lats tightened throughout the entire motion.

•Release your shoulder blades at the end of each rep and initiate each new rep by depressing your

shoulder blades.

Back Exercises

FINISH

START

FINISH

START

25

Advertising