Lenze 8400 - Manual (Page 85)

Lenze · 8400 protec HighLine · Reference manual · DMS 3.0 EN · 03/2013 · TD05
85
3 Commissioning
3.9 Commissioning of the "Switch-off positioning" technology application
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.9.5 Saving parameter settings safe against mains failure
The parameter set must be saved to the device safe against mains failure to prevent parameter
settings becoming lost due to mains switching.
• Save parameter set.
3.9.6 Enable controller and test application
1. Enable controller
• If there is no other active source for the controller inhibit, the controller changes from the
" SwitchedOn " status to the " OperationEnabled " status.
• The Diagnostics tab and C00158 display all active sources for the controller inhibit.
2. Select the respective control signals via the digital inputs.
Related topics:
 "Inhibit at power-on" auto-start option ( 119)
 Trouble-shooting during commissioning ( 53)
 Diagnostics & error management ( 553)

Stop!
Before stipulating a speed setpoint, check whether the brake in the form of a holding
brake on the motor shaft has been released!

Note!
Observe the actual speed value (display in C00051 ) as well as the LED status displays .
( 554)