Loadstar Sensors DS-3000 Digital Load Cell Display & Controller - Manual (Page 20)

DS-3000U DS3000 User Guide
Loadstar Sensors, Inc. Page: 20 / 48 033-01419 Rev. 4
7.11 What if I’ve lost the password, How can I get into program mode?
1. Unfortunately, you can’t. If you lose the password, you have to send the unit back to
Loadstar Sensors, so we can reset the unit for you.
7.12 How do I reset the unit to factory defaults?
1. Press and hold menu until “Enter Pass” and “000000” appear on the display
2. Press the up or down keys to select the programming mode password (default is
000001)
3. Press enter
4. You are now in programming mode at the dsplay prompt. Press mode until you reach
the option menu.
5. Press down, to the factor entry. Press enter, and once all the LED decimal points
illuminate, the unit will be reset back to factory defaults. NOTE: All programming and
other customizations WILL BE LOST.
6. Now exit programming mode: Press mode until the run entry
7. Then press enter to return to run mode.
7.13 Is there an easy way to see what is currently programmed
or
7.14 How do I check my programming?
The easiest way to do this is using the REMOTE interface. See chapters Installing Virtual com port drivers
and Remotely Programming the DS-3000. Once you are connected to the DS-3000 using Hyperterminal, or
another terminal program from your host PC, you may issue the command: settings <enter>