Loadstar Sensors LoadVUE (LV-400,LV-1000,LV-4000,LV-7000) Load Cell - Manual (Page 12)

LoadVUE User Guide • 10
Loadstar Sensors, Inc. • www.loadstarsensors.com
Driver Installation and Hyperterminal Operation of iLoad Digital
USB Sensors
Driver Installation Driver Installation Driver Installation Driver Installation
Insert the iLoad Digital USB Driver CD OR the LoadVUE or LoadVUE Lite CD into your computer’s
drive. If you have downloaded the driver files from our web site onto a location in your hard disk,
substitute that location instead of the CD drive in the instructions below. Drivers for Windows XP
and Windows Vista are available here.
If you have purchased LoadVUE or LoadVUE Lite software with your iLoad Digital USB sensor,
please ensure that you install the drivers as described in this document before you install the
LoadVUE software. Also note that the screen shots in this document are for Windows XP, but the
process is the same with Windows Vista although the appearance of screens is different.
Note: The iLoad series sensors are intended for use with an NRTL approved device such as a
computer or regulated power supply.
Plug in your iLoad Digital USB sensor into an available USB port on your Windows computer. The
New Hardware Wizard window will come up in a few seconds.
Select the option for “No, not this time” and click Next .
On the next screen select the option for “Install the software automatically” option and click Next .
Your computer should scan the CD to find appropriate drivers for the sensor.