Loadstar Sensors LoadVUE (LV-400,LV-1000,LV-4000,LV-7000) Load Cell - Manual (Page 25)

LoadVUE User Guide • 23
Loadstar Sensors, Inc. • www.loadstarsensors.com
Example 1: The relay is closed from 0 – 10 lb.
The relay is open for values > 10 lb.
Set L2 = 10, L1=10
Select ‘Close’ for values below L1 and ‘Open’ for values above L2. The option between
L1 and L2 is ignored since L1 and L2 are equal.
Enter 0 on the ‘Simulate-Min’ box and 20 on the ‘Simulate-Max’ box. These are just
values you enter to verify the operation of the relay, and do not have to match actual
loading min and max.
Move the slider between the Min and Max values to test the relay operation.
Note: This simulation will actually open and close the relay so you can verify that your settings are
working properly. Please ensure that the relay is disconnected from the external circuitry to avoid
triggering any real equipment by accident.
Simulation area, use the slider to verify
if the relay is operating as per your
settings. Note:
The relay will open and
close, so please make sure the relay is
disconnected from the external circuit, if
necessary.
> 10 lb
<= 10 lb
Use these buttons to
open and close the
relay manually.