Mig/mag/co2 – Longevity MIGWELD 250 MP User Manual
Page 30
Advertising
MIGWELD 250 MP
MIG/MAG/CO2
1. Push the
<Welding Process>
button to choose the <CO2> process.
2. Push the
<2T/4T>
button to choose hold type of 2T or 4T.
3. Push the
<Process Selection>
button to select the welding process; check the
panel
<Process Indication>
, the available setting will be lighted on by pushing the
Left or Right selection button.
4. Use
<Encoder 1>
&
<Encoder 2>
to adjust the welding parameters.
5. Push
<Gas Check>
button to check the gas before start welding.
<Encoder1>
used to adjust the Current (A) showed at <DISP.1>
<Encoder2>
used to adjust the Volts (V), Time (S) showed at <DISP.2>
29
Advertising