Longevity MIGWELD 250 MP User Manual
Page 36
MIGWELD 250 MP
Store Memory
• In the <Memory Settings> buttons you can:
1. Set the welding parameters and store it into memory. The memory
capacity right now is valid to store 10 sets.
2. Select the memory channel for direct welding jobs.
3. Also, you can select a memory channel and open the parameter to make
for fast adjusting from the memory parameters.
• Also, you can clear all the memories and restore to the factory settings.
1. Push the
<Welding Process>
button to enter into the
<DPMIG>
mode and
hold this button at least 5 seconds until the
<SETUP>
button is lit.
2. Push the Left/Right button on the <Process Selection> and check the
<DISP.2>
&
<DISP.3>
showed “Lod dEF”.
3. Turn the
<Endoder 2>,
and the
<DISP.2>
&
<DISP.3>
will refresh in 2
seconds, and the setting is finished.
4. Restart (Power on) the machine and the memory would be restored to the
factory settings.
35