Longevity MIGWELD 250 MP - Manual (Page 6)

MIGWELD 250 MP
Safety Tips
Consider the following tips to ensure safe operation of your welding/cutting equipment:
•
Ensure that this welding equipment is installed in an area free of corrosive chemical gases,
flammable gases or materials, and explosive chemicals.
•
The area should contain little dust, and have a humidity of no more than 80%.
•
Operate the welding equipment in an area sheltered from direct sunlight and precipitation.
Work area temperature should be maintained at -10
°C to +40°C;
•
If, because of an overload, the machine suddenly stops, and it is necessary to restart it, leave
the internal fan operating to lower the inside temperature.
•
Always wear protective clothing and a welding mask to protect your skin.
•
Wear safety goggles designed to darken the arc generated by your machine.
•
Wear suitable noise protection to protect your hearing.
•
Ensure that machine is grounded through the power cord or on the machine case.
•
Never operate the machine in bare feet or on a wet floor.
•
Never switch the machine off while it’s in use. Doing so will damage the internal circuitry.
•
Ensure that your circuit breaker is rated to handle the current requirements of your machine.
•
Use a UL approved receptacles and plugs with your machine. Never hard wire the machine to
main power.
•
Work in a well ventilated area to avoid smoke. Keep your head out of the smoke. Ensure that
air is flowing away from you to avoid inhaling smoke.
•
Ensure proper ventilation through the machine’s louvers. Maintain a distance of at least
12 inches between this equipment and any other objects in the work area.
•
Use a screen or curtain designed to keep passers by from viewing the arc.
•
The arc spray and metal spray from machine use may cause nearby fires. Use caution.
•
If, after reviewing this manual, you have any problems in setting up or operating your
machine, contact us at [email protected].
5