Marshalltown 46E11 Cyclone Power Trowels - Manual (Page 10)

1A
OPERATIONS
1A-8
Crank Wheel Pull Handle
The Cyclone™ Power Trowel is a modern high production machine. Finishing rate will vary depending on operator
skill and job conditions. The trowel has four finishing blades. The standard duty gearbox is designed to provide exceptional
performance low maintenance and trouble free use under the worst conditions. All Cyclone™ Power Trowels are
equipped with a safety shutdown switch and a low oil shutdown alert for added job safety and engine protection. Operating
time between fuel refills is approximately 2-1/2 to 3 hours with rotor speeds between 80 and 120 rpm. Cyclone™ Power
Trowels
are the most technically advanced trowels on the market today. With proper maintenance and use your trowel will
provide you with exceptional service.
1.8 Before Starting
Before starting trowel check the following:
*Oil level in engine
*Oil level in trowel gear box
*Fuel level
*Condition of air filter
*Condition of trowel arms and blades
1.9 Starting
Before starting the operator must know the
location of all the controls.
Move the
choke lever to the closed position
to start a cold engine. The choke may not be
needed if the engine is warm or the air tem-
perature is hot. In this case keep the choke
lever open. Pull
crank wheel pull handle
until engine starts.
1.7 Description
Engine ON/OFF
Fuel ON/OFF
Choke Lever
Throttle Lever