Marshalltown 46E11 Cyclone Power Trowels - Manual (Page 13)

1A
OPERATIONS
1A-11
1.14 Drive Belts
A
B
C
D
D
E
Figure 1 Figure 2 Figure 3
To Replace Belts:
1. Remove belt guard (A) by removing the four belt guard mounting bolts (B).
See figure 1.
2. Rotate the pulley (C) while pulling the bottom of the belt (D) out. See figure 2.
3. After the belt (D) has cleared the pulley, remove it from the clutch (E). See figure 3.
4. Repeat steps 1 through 3 in reverse order to install the new belt.
NOTE: When replacing the belt be sure that the pulley and the clutch are in perfect alignment. If the belt is allowed to lean
to the left or the right it will cause the clutch to engage prematurely on start-up.
1.15 Compensating for Bent Trowel Arms
A
B
1. Loosen nut (B) slightly.
2. Adjust bolt (A) until trowel blade is level.
3. Tighten nut.
(See figure 4)
Figure 4