Marshalltown FCS86 SURFACE SHARK Floor Stripper - Manual (Page 17)

FCS86 SuRFACE ShARK™ FLooR STRIPPER PAgE 17
UNEXPECTED MOVEMENT CAN ALLOW
THE MACHINE TO FALL BACK TO THE
WORK SURFACE. THE RESULT CAN BE
PROPERTY DAMAGE AND/OR PERSONAL
INJURY.
5) Reinstall the protective blade cover. Exercise
extreme caution when removing and/or reinstalling
the protective cover. use the T-handled Allen wrench
to loosen the button head cap screws which secure
the blade between the fence plate and exciter plate.
Remove the blade and store in an appropriate location.
use the T-handled Allen wrench to tighten the button
head cap screws. Keep the button head cap screws
tight to minimize becoming lost.
For all blades tighten the button head
cap screws only with the T-handled Allen
wrench provided. Do not utilize another
wrench type and/or configuration. The T-
handled Allen wrench was chosen to place
body parts a practical distance from the
blade during the fastener tightening and
loosening process. Do not apply excessive
impact force to the button head cap screws.
Ample seating torque can be applied by the
T-handled Allen wrench. Excessive impact
force can cause the T- handled Allen wrench
to slip out of the button head cap screw,
resulting in property damage and/or personal
injury.
Do not substitute a different fastener type
for the button head cap screw configuration.
The button head configuration was chosen
for operational considerations. The use of
other fastener types can increase the
potential for property damage and/or
personal injury.
BLADES ARE EXTREMELY SHARP.
CONTACT WITH THE BLADE CAN RESULT
I N P R O P E R T Y D A M A G E A N D / O R
P E R S O N A L I N J U R Y . B L A D E S A R E
PROVIDED WITH A PROTECTIVE COVER
OVER THE CUTTING EDGE. EXERCISE
EXTREME CAUTION WHEN REMOVING
AND/OR REINSTALLING THE PROTECTIVE
COVER. STORE THE BLADE WITH THE
P R O T E C T I V E C O V E R P R O P E R L Y
INSTALLED TO MINIMIZE THE POTENTIAL
FOR BLADE DAMAGE AND/OR PERSONAL
INJURY.
6) Return the Floor Stripper to its normal operating
position.
7) Determine that the oN/oFF switch located on the
operator handle is in the oFF position. If the Floor
Stripper is to be used immediately, then reconnect the
extension cord or Floor Stripper to the power source.
UNEXPECTED MACHINE START UP CAN
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.