MBT Lighting SM100DMX - Manual (Page 2)

MBTLighting.com SM100DMX “Flurry DMX” User Manual
2/3
2. In DMX mode, machine receives consecutive DMX value from channel 1 and DMX address
decides snow volume and controls wind pump. Z-6 controller box has three functions:
· Manual mode –max volume of spraying snow
· Consecutive mode-volume of spraying snow can be adjusted.
· Interval mode-volume of spraying snow can be adjusted
OPERATIONAL INSTRUCTION
1.Switch on and begin
Plug power cord into a grounded electrical outlet. Turn power switch on rear of unit to “ON”
position. For the 110V models, use 3-prong grounded electrical outlet only. Before using, make
sure that the unit is installed at the rated voltage. Power cord should be grounded. Press the
switch on the rear of panel to “ 1” and LED indicator will be on.
2.Controller box control (MASTER mode)
A. Set dipswitch10 is off and connect Z-6 with snow machine. The Red LED indicator ON means
controller box has connected with power. Blue LED is off.
B. Press the Green knob (MANUAL button) to spray snow manually.
C. Press the Red knob or CONT button to spray snow consecutively and rotate VOLUME knob to
adjust snow volume.
D. Press the Yellow knob or TIMER button to spray snow at 10 seconds ~ 20 minutes intervals.
Rotate the INTERVAL knob to adjust interval time. Rotate the VOLUME knob to adjust snow
volume in interval mode. Fixed time of spraying snow or blowing wind is 30 minutes.
3. DMX control
Set dipswitch10 to ON and connect DMX signal cord with snow machine. When there has DMX
signal, the blue LED will flash. Set up initial DMX channel via DIP switch and then snow machine
can be controlled by DMX channels. The first channel controls snow volume and the second
channel controls wind volume.
OFF
1 2 3 4 5 6 7 8 9 10
ON
1 2 4 8 16 32 64 128 256 ON
0 0 0 0 0 0 0 0 0 OFF
AddR=Add1+Add2+Add3+---------Add9
For example1、3、7、9为ON；2、4、5、6、8为OFF时
AddR=1+0+4+0+0+0+64+0+256=325