MK Diamond Saw Tent - Manual

SAW ASSEMBLY INSTRUCTIONS
1315 Storm Parkway, Torrance, CA 90501 | P 800.421.5830 | www.mkdiamond.com | F 310.539.5158
Step (1) Always check the floor for high nail heads, screws, and
other sharp objects before setting up your SAW TENT. Lay down
a sheet of plastic to protect the floor and then lay out the black
plastic pan.
The MK Diamond Saw Tent is designed to
contain the spray and debris when cutting tile or
masonry material. You can cut anywhere without
the worry of your surroundings. It is easy to
assemble and retracts into a small storage bag.
Step (2) Cut a piece of ¼ ” Backer Board 46.5” X 59.5” to install
inside the black pan. The Backer Board will give the Saw Tent
aluminum structure a firm base to stand on. The Backer Board
will also protect the black pan from being punctured by sharp
pieces of tile falling off the tile saw.
Step (3) Take the aluminum structure and press it until it extends
fully and locks open. Pull the aluminum frame into the four corners
of the pan until it is fully extended and tight. The pan will now be
open and the perimeter will be standing up, ready to receive the
clear plastic cover.
Step (4) Install supports for both sides. Now would be a good
time to set up your saw stand and the saw, both inside the
Saw Tent.