MK Diamond MK-1080 - Manual

Tool Tips
Operation & Safety
MK-1080
Head Stop Installation
MK-1080 Head Stop Installation Revision 12/00, Effective Date: 11/27/00
Application: The MK-1080 Cutting Head Stop prevents the
user from cutting through the Movable Cutting Table.
Step Action
1. Disconnect Saw
a) Unplug the GFCI from
Power Source
b) Unplug Saw from GCFI
2. Lock Cutting Head
a) Lock the Cutting Head
in the "UP" Position
3. Orient Stop
a) Orient Rubber Stop to
inside of Rear Post
Adjusting Groove
4. Install Stop
a) Press Rubber Stop into
Adjusting Groove until
"flush" with Rear Post
Safety Practices:
Always use with a
GFCI protected
receptacle.
Always wear eye
protection when
operating or working
near this equipment.
This tool produces
considerable mist and
sharp debris under
normal operation.
Wear a dust mask to
avoid breathing
heavy dust or mist,
and to protect against
debris.
Keep the blade guard
in place at all times.
Always disconnect
the power cord before
cleaning, replacing
the blade, or
servicing the tool.
Never leave the saw
running unattended.
Turn the power off.
Never use the saw on
an unsupported
surface to avoid
accidents.
5. Verify Stop
a) Release Cutting Head
b) Verify Rubber Stop
prevents Cutting Head
from contacting Cutting
Groove of Movable
Cutting Table
Disconnect Saw
Rotate Clockwise
to Tighten
Lock in "UP"
Position
Adjusting Groove Install Stop
Blade does
not Touch
Stop Installed