MK Diamond MK-1080 - Manual

MK-1080 Blade Alignment Revision12/00, Effective Date: December 04, 2000 Page-1
MK-1080 BLADE ALIGNMENT PROCEDURE
The Movable Cutting Table of the MK-1080 may become misaligned with the Cutting Head of the Tile Saw over
time. Should misalignment occur, perform the following steps to realign the Tile Saw.
NOTE: If alignment problems are the result of a warped blade, a bent frame or bent support arm, or, if alignment
is off by more than 1/8-inch, contact the MK Diamond Service Center – (800) 474-5594
Tools Needed:
Preparation:
Combination Square (Square)
12-inch or Greater
1/4-inch Wrench
or
MK Dual Hole Box Wrench
(A)
Remove Tile Saw
from Power Source
(C)
Inspect Tile Saw
for damage
(D)
Inspect Diamond Blade
for damage
(B)
Remove Water Pan
(E)
Loosen front and rear
Adjustable Frame
Retaining Clamp Bolts
Disconnect Saw
Remove Pan
Inspect
Blade
Inspect Cutting Head Inspect Frame
(F)
Loosen front and rear
Adjustable Frame
Adjusting Bolts
Inspect Cutting Table
Turn Counter-
clockwise
to Loosen
Turn Counter-
clockwise
to Loosen