Mk-1080 blade alignment procedure, Rough alignment: final alignment: verification – MK Diamond MK-1080 User Manual
Page 2
MK-1080 Blade Alignment
Revision 12/00, Effective Date: December 04, 2000
Page-2
MK-1080 BLADE ALIGNMENT PROCEDURE
Rough Alignment:
Final Alignment:
Verification:
(B)
Tighten front and rear
Adjustable Frame
Adjusting Bolts
(E)
Position end of Square
against Blade
(A)
Pull Movable Cutting Table
to front of Tile Saw
(B)
Position Square flat on Movable
Cutting Table against Ruler/Stop
(F)
Move Adjustable Frame until
Square rests evenly
across Blade
(C)
Position front of Square
against Blade
(D)
Move Adjustable Frame until
Square rests evenly across Blade
(B)
Move Adjustable Frame
until Blade is centered in
Cutting Groove
(A)
Move the Cutting Table back and
forth to verify Blade is even
across all points of Square
(A)
Position Cutting Head
to normal Cut Depth
Center Blade
In Cutting Groove
Position Cutting
Table to Front
Ruler/Stop
Place Square
Against
Ruler/Stop
End of Square
Blade
Front of
Square
Front of Square
Flush with Blade
Set Square Off
Blade
Move Cutting
Table
(B)
Tighten front and rear
Adjustable Frame
Retaining Clamp Bolts
Adjustable
Frame
Blade
End of Square
Flush with Blade
Adjustable
Frame
Blade
Turn Clockwise
to Tighten
Turn Clockwise
to Tighten
Adjust Cutting
Head to Cut Depth
of Approx _”
Blade
Verify Gap Even
Along Length
of Square