MTS Series 244 Actuators - Manual (Page 46)

About Installation
Installing the Series 244 Actuator depends on the testing application.
• For materials or component testing, the actuator is typically installed in a load frame or test fixture.
• For structural or vibration testing, the actuator is typically secured to a reaction mass using a swivel or
pedestal base.
Load Units
When the Series 244 Actuator is mounted in a load frame configuration, the actuator is installed in the load
frame at the factory. Actuator options, such as servovalves and manifolds, are also installed on the actuator
at the factory. The only installation required is to connect system hydraulic hoses and system cables.
46 Series 244 Actuators Product Information
Installation