MTS Series 244 Actuators - Manual (Page 60)

Sideload Calculation Constants
Cyclic Sideload K Rod Diameter G Bearing Area E Bearing Length D Bearing Spacing
A Model
0.600 1.75 3.50 1.7100 5.960
244.11
0.600 1.75 3.50 1.7100 5.960
244.12
0.140 2.75 6.26 1.9380 5.820
244.21
0.140 2.75 5.84 1.8630 5.475
244.22
0.140 2.75 5.98 1.8880 5.425
244.23
0.068 3.75 10.03 2.1340 5.825
244.31
0.026 5.25 22.37 2.8700 6.530
244.41
0.015 6.00 24.69 2.8125 7.865
244.51
Note:
The equations included in this procedure assume that the values of F and P are measured in pounds
force and that B, C, and S (stroke) are measured in inches.
1. Determine the magnitude of nonaxial loads F and P and the point of application of these loads (B and C
respectively). These parameters are dependent on the test setup configuration. If any parameter is variable
during the test, use maximum values.
60 Series 244 Actuators Product Information
Operation