MTS Series 651 Environmental Chambers - Manual (Page 21)

Series 651 Environmental Chamber 21
6. Use the hand-operated screw jack to adjust the height of the chamber so that
the cart’s lift arms are slightly higher than the top surface of the load unit’s
baseplate.
Note The Model 651.05-02 Environmental Chamber includes feet for tabletop
applications. Adjust the height of the feet for the application.
7. If you have an environmental chamber without U-plugs (Models 651.04-01
and 651.05-02), install the grips now. See your grip manual.
Do not change the position of the chamber after the crosshead has been
adjusted and the displacement limits have been set.
Damage to the chamber or fixtures can result.
After the environmental chamber is installed, see your test controller and grip
manuals for information about installing a specimen.
8. Install the specimen.
9. If desired, install extensometers, thermocouple wiring, and any other
specimen instrumentation on the specimen at this time.
10. Reinstall the U-plugs in the chamber removed in Step 4.
Eurotherm 2404
CAUTION