MTS Advantage Screw Action Grip - Manual (Page 20)

MTS Advantage™ Screw Action Grips Installation 20
3. Insert the adapter into the load unit component (force transducer
attachment fixture, lower mounting fixture, and so forth). Align the
holes in the adapter and the load unit component and insert the pin.
4. Preload this connection by tightening the locknut bearing on the adapter
against the surface of the load unit component. Tighten sufficiently to
ensure that there is no slack during testing.
5. Set the grip on the adapter, align the grip, and secure the grip to the
adapter using the supplied socket head cap screw.
6. Repeat Step 5 for the other grip.
Socket Head Cap
Screw
Adapter
Locknut Bearing
Load Unit
Component