MTS Advantage Pneumatic Grips - Manual (Page 32)

Advantage™ Pneumatic Grips
Installation Without Using the Mounting Pin
Installation 32
Installation Without Using the Mounting Pin
This section describes how to install the Advantage Pneumatic Grips by bolting
them directly to a load unit actuator and force transducer (usually in a
servohydraulic test system).
Note You will need the appropriate attachment kit to install the grips in a
servohydraulic load unit.
Non-pinned Installation Components
End Cap
Cap Screw
Grip Assembly
Air Fitting
Actuator
Spacer
10 N 200 N/2000 N 10,000 N
Spring Pin
Threaded
Adapter
Jam Nuts
Washer