MTS Advantage Pneumatic Grips - Manual (Page 56)

Advantage™ Pneumatic Grips Maintenance 56
Cleaning face surfaces Periodically check the face surfaces for debris buildup. Clean them if necessary.
Face surfaces will wear out eventually and need to be replaced. Use only MTS
replacement parts. See
“Selecting Face Surfaces” on page 40 for replacement
parts.
Do not use oil or alcohol based solvents or abrasive material to clean rubber
face surfaces.
Using oil or alcohol based solvents or abrasive material such as Scotch-Brite™ on
rubber face surfaces can cause product damage.
Rubber face surfaces should be cleaned using a clean soft cloth dampened with a
water based solvent. Do not use oil or alcohol based solvents or abrasive material
such as Scotch-Brite™.
Metal face surfaces can be cleaned using an oil or alcohol based solvent and a
soft wire brush. Be sure to brush parallel with the grooves.
Spare parts kits
The spare parts kits include seals, gaskets, washers and grip face pins and the
lubricant necessary for grip maintenance.
CAUTION
Model MTS Part Number
10 N 100-044-618
200 N 100-044-616
2000 N 100-044-617
10,000 N 100-044-619