MTS Multi-Pump Control Manager - Manual (Page 6)

Multi-Pump Control Manager
6
Intended Use
Introduction
Note MTS can provide the BCI without the Supervisor and dedicated PC. In
this case, the BCI commons the signals required for the HPU(s) to work
as a system controlling the cooling solenoids, bypass solenoids, and
E-Stop chain (which includes external E-Stops). In this case, all control of
the HPUs is accomplished at the HPU HMIs.
Intended Use
The intended use is to provide remote operation and status information for one or
more HPUs. Before you attempt to use your MTS product, read and understand
the manuals that accompany this product. Improper installation or operation of
this product can result in hazardous conditions that can cause severe personal
injury or death, and damage to your equipment and test specimen.
HPU #2
HPU #1 E-STOP #1
E-STOP #2
E-STOP #8
SFM #1
SFM #7
SFM #8
OR
OR
OR
SUPERVISOR PC
LIGHT STACK(S)
SUPERVISOR
E-STOP
HPU #8
BCI
(DAISY CHAIN MULTIPLE LIGHT BARS,2 AMPS
PER CHANNEL NOT TO EXCEED 6 AMPS TOTAL)