MTS Isolation Service Manifold Controller - Manual (Page 14)

Isolation Service Manifold Controller 14
Component Identification
Hardware Overview
Component Identification
Refer to the following table for information on the components shown below.
Number Component Description
1 Power switch Switch - Turns electrical power on (I) and off (O)
2 Main power in Jack (2) and strain relief (2A) - 100-240 VAC, 50/60 Hz, 4-2 Amps
3 ID plate Label - Identification label provides component specific information.
4 J1A/B Connector, 9-pin D, male - refer to “J1A/B Connectors” on page 15.
5 Fault Reset A/B Mini switch - Used to reset a fault (providing the fault has been
corrected).
6 Fault A/B Indicators - Indicate various fault conditions depending on flashing
sequence.
7 Power OK Indicator - Indicates the unit is on and power is satisfactory.
8 J3A/B J3A=Channel A; J3B = Channel B. Connector 25-pin D, female - refer to
“J3A/B Connectors” on page 17
9 J2A/B J2A=Channel A; J2B = Channel B. Connector 15-pin D, female - refer
to
“J2A/B Connectors” on page 16
10 J28A/B J28A=Channel A; J28B = Channel B. Connector 9-pin D, female - refer
to
“J28A/B Connectors” on page 18
10 9 8
7 6
5
4
3
2A 2
1