MTS Isolation Service Manifold Controller - Manual (Page 27)

Connect to main power
Isolation Service Manifold Controller Installation 27
Installation
Installation involves plugging it in to the wall outlet and cabling it to system
components.
Connect to main power
Be sure the power switch (I/O) is in the off (O) position. Connect the power cable
to the ISM Controller power connector. Plug the other end into the wall outlet or
system power strip.
Cabling
Refer to the following illustrations for cabling information.
P1
494.42
ISM Controller
HSM
292, 298
P28
574730-XX
HSM
290, 293
or
Existing
HSM
Cable
D9 to CPC Adapter
(if needed)
100175734 (290, 293)
100188068 (292, 298)
P2
ISM
Pilot
Pressure
Block
P3
574745-XX
575142-XX
Install jumper
100225251 if
no pilot pressure
block
P28