MTS Series LX Laser Extensometer - Manual (Page 50)

LX Laser Extensometer
Serial I/O Port Cable Connections
Operation 50
Sn Scans
Averaged Sets the number of scans over which the measurements are averaged. The choices are as
follows:
S1 2 Scans Averaged
S2 4 Scans Averaged
S3 8 Scans Averaged
S4 16 Scans Averaged
S5 32 Scans Averaged
S6 64 Scans Averaged
S7 128 Scans Averaged
S8 256 Scans Averaged
S9 512 Scans Averaged
Mn Measurem
ent Type Sets the Measurement Type. The number after the command specifies the choice for this
parameter and is a numeric value from 1 to 9 or the letter A as follows:
M1 T
2
-T
1
mode
M2 Reserved (T
3
- T
1
)
M3 Reserved (T
4
- T
I
)
M4 Reserved (T
3
- T
2
)
M5 Reserved (T
4
- T
2
)
M6 Reserved (T
4
- T
3
)
M7 Reserved (Curve Fit T
1
)
M8 Reserved (Curve Fit T
2
)
M9 Reserved (Tsw)
MA Multisegment mode
L0 Laser OFF Disables the laser beam scanning.
L1 Laser ON Enables the laser beam scanning.
Command List* (part 3 of 4)
C OMMAND D ESCRIPTION
* These commands use capital alphanumeric characters.