General setup commands – New Era HEATER-KIT-1LG Syringe Heater User Manual
Page 12
New Era Pump Systems Inc.
www.SyringeHeater.com
Model HEATER-KIT-1
Publication #1200-01
11
04/23/14
TEMPERATURE FINE TUNE SLOW DOWN DELTA
FTS [ nnn ]
Set/Query Fine Tune Slow down degree setting.
Query response: <nnn>
TEMPERATURE FINE TUNE HOLD PERCENTAGE
FTH [ nnn ]
Set/Query Fine Tune temperature hold percentage.
Query response: {nnn}
CALIBRATION
CAL [< L | H > [<nnn>] ]
Heating pad calibration. See calibration section for details.
HEATING PAD SELECTION
PAD [ n ]
Heating pad calibration setting. 1 – Default. 0 – Calibrated.
Query response: <n>
TEMPERATURE UNITS
UNT [ C | F ]
Set/Query temperature units
Query response: {C | F}
GENERAL SETUP COMMANDS
SAVE NEW SETTINGS
SAV
Save all new settings in non-volatile memory
POWER FAILURE MODE
PF [ 0 | 1 ]
Set/Query Power Failure mode
Query response: {0 | 1}
LOCK OUT MODE
LOC [ < 0 | 1 [nnnn] >
Set/Query Lock Out mode
Query response: {0 | 1 <nnnn>}
NETWORK ADDRESS
ADR [ nn ]
Set/Query RS-232 network address
Query response: <nn>
FIRMWARE VERSION
VER
Query firmware version.
Query response: NE800V<n>.<nn>
SYSTEM RESET
RESET
Reset all parameters to factory defaults