Northern Connectors Harting Han-Yellock Industrial Connectors - Manual (Page 4)

25
.
04
Han-
Yellock
Han-Yellock ®
Inserting the module into the hoods/housing
• The Han-Yellock ® module should only be in-
serted into the „A“ plug-in position in the metal
clamp.
① plug-in position „A“
• The illustration shows the orientation of the mo-
dule (see arrangement of contacts 1 ... 5).
① Carrier hood, mating side
② Carrier hood, connection side
③ Housing, bulkhead mounting, mating side
④ Housing, bulkhead mounting, connection side
• A distinct click can be heard when the module
snaps into position. It is then pushed along the
rail to its final position. The plug-in slots must
always be completely filled.
Disassembling the Han-Yellock ® module
• The removal tool (part no.
"https://b2b.harting.com/ebusiness/en/
11 99 000 0001
"
) is re-
quired to take out the module.
• The following illustration shows how to insert
the removal tool into the metal clamp. The tool
should then be pressed down until it reaches the
end stop.
• The tool is then pulled back and the module
comes out of the housing.
• The removal can be made from the connection
side as well as from the mating side.
① removal tool
② housing, bulkhead mounting
The process is identical for both housings, bulkhead
mounting, and carrier hoods.
The removal tool can be stored on the carrier hood:
① removal tool
② carrier hood