MacDon HC10 for D-Series - Manual (Page 41)

UNLOADING AND ASSEMBLY
3.4 Installing Deck Brackets
To install the deck brackets onto the header, follow
these steps:
1. Install the two lower brackets (A) onto the inside of both
center header legs with two bolts and nuts (B) in each
bracket.
Figure 3.8
2. Install right-hand upper bracket (A) and spacer (B) on
the right-hand center leg as shown and install nut (C).
NOTE: For headers with a sheet metal hose
cover, install bolts from the outboard side.
3. Install the other bolt through the bracket and spacer
and secure with a nut (D).
4. Tighten both bolts.
Figure 3.9: 15 ft Header Shown
5. Install the left-hand upper bracket (A) and spacer (B)
onto the inboard side of left-hand center leg as shown.
Figure 3.10
169254
33
Rev. D