11lubricating the conditioner, 1greasing procedure, Lubricating the conditioner – MacDon HC10 for D-Series User Manual
Page 64: Greasing procedure, Caution, 11 lubricating the conditioner
Advertising

3.11
Lubricating the Conditioner
3.11.1
Greasing Procedure
CAUTION
To avoid personal injury, before servicing header
or opening drive covers, follow procedures in
Preparation for Servicing, page 87
1.
To avoid injecting dirt and grit, wipe grease fitting with
a clean cloth before greasing.
2.
Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
3.
Leave excess grease on fitting to keep out dirt.
4.
Replace any loose or broken fittings immediately.
5.
If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway. Replace
fitting if necessary.
169254
56
Rev. D
Advertising