MacDon CA25 OM - Manual (Page 40)

SECTION 7. OPERATION - JOHN DEERE 60, 70, and S SERIES
169593
38
Revision B
f. Disconnect hydraulic/electrical coupler from
combine as follows:
1. Disconnect harness (P) from combine
harness.
2. Remove lynch pin (H), and slide lock (J) to
release handle (K).
3. Lift handle (K) to full vertical position to
release coupler (G) from combine.
4. Position coupler (G) on adapter receptacle,
and lower handle (F) to lock coupler.
5. Push handle (K) on combine toward feeder
house to disengage feeder house pin (L)
from adapter.
g. Lower feeder house until saddle (M)
disengages and clears adapter support (N).
h. Slowly back combine away from adapter.
K
G
G
F
M
N
H
J
K
G
P
L
K