Retsch GM 200 - Manual (Page 20)

Operating the machine
20
Pos : 8. 14 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Bedienung des G erät es @ 0\ mod_1229416465774_9. doc @ 5052 @ @ 1
5.4 Operating the Device
Pos : 8. 15 /00004 Warnhinweis e/ V0007 VOR SICHT Her abfall en des G erät es / Standf estig kei t @ 1 \ mod_1248178329919_9. doc @ 11690 @ @ 1
CAUTION
Device falling down
Incorrect assembly or unsuitable workplace
- The appliance is very heavy and can therefore cause serious personal injuries if
it falls down.

Operate the device only on a sufficiently large, firm, skid-resistant and
steady workplace.

Make sure that all equipment feet are steady.
Pos : 8. 16 /00004 Warnhinweis e/ V0044 VOR SICHT G ehörsc haden (GM 300, SM 200, SM 300) @ 1 \ mod_1248181519795_9. doc @ 11731 @ @ 1
CAUTION
Damage to hearing
The level of noise can be high depending on the type of material,
the knife used, the speed set and the duration of the grinding
process.
- Noise that is excessive in terms of level and duration can cause
impaired or permanently damaged hearing.
• Ensure suitable sound-proofing measures or wear
hearing protection.
Pos : 8. 17 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Ei n- / Aussc hal ten @ 0\ mod_1229416527496_9.doc @ 5058 @ @ 1
5.5 Switching On and Off
Pos : 8. 18 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ GM200 (2010)/ 0015 GM200N Bedienung/ 1515 GM 200_2010 Modul Ei n und Aus schalt en @ 3\mod_1279721702190_9. doc @ 21559 @ @ 1
The main switch is located on the reverse side of the device (L1).
• Switch the main switch on.
The grinding time last used appears in the TIME display.
The speed last used appears in the SPEED display.
Fig. 6: Main switch
L1